5.0(65+ reviews)
    24/7 emergency commercial response

    Commercial HVAC Repair Across the NYC Metro

    One number for every system in your building. Com+ Mechanical repairs rooftop units, chillers, boilers, VRF, air handlers, cooling towers, refrigeration and controls — with 24/7 response for property managers, building owners and facility teams across the five boroughs, Long Island, Westchester, northern NJ and Stamford.

    Building HVAC Problems We Resolve

    Whole zones or floors with no cooling or heat

    Traces back to a failed rooftop compressor, a tripped chiller, a locked-out boiler, or a stuck VAV/zone valve. We isolate the failed system across the airside and control path rather than resetting and hoping it holds.

    Equipment short cycling or repeatedly locking out

    Pressure-switch, control-board, sensor or flow faults — often paired with dirty coils, low refrigerant or an oversized unit. Short cycling spikes energy use and shortens compressor and burner life.

    Refrigerant leaks and declining cooling capacity

    Leaking coils, fittings, Schrader cores or aging R-22 charges. We electronically leak-detect, repair the source, and recover and recharge under EPA Section 608 — not just top off and rebill.

    Tenant comfort complaints with no obvious fault

    Economizer dampers stuck open, failed outdoor-air or zone sensors, drifting BAS sequences, or unbalanced airflow. We diagnose at the controls and airside, not just the equipment.

    Water leaks, flooding or staining in mechanical spaces

    Clogged condensate drains, rusted drain pans, failed condenser-water valves, or pump-seal and piping leaks. Left alone these cause interior damage, mold risk and tenant claims.

    Recurring failures on equipment past its service life

    Compressors, heat exchangers and motors that keep failing on aging units. We quantify run hours and repair history so you can decide between another repair and a planned capital replacement.

    Whole-Building HVAC Repair, One Accountable Vendor

    A commercial building rarely runs on a single piece of equipment. A typical NYC property stacks packaged rooftop units, a central chiller plant or VRF system, hydronic or steam boilers, air handlers and fan-coils, cooling towers, exhaust and makeup-air units, walk-in refrigeration and a building automation system tying it all together. When any link in that chain fails, tenants feel it — and the fix often crosses mechanical, electrical and controls disciplines at once. Com+ Mechanical is the single commercial contractor you call for all of it. Our technicians diagnose the actual root cause across refrigeration, hydronic, gas-fired, airside and control circuits, document findings with photos for your records, and give building staff a clear repair-versus-replace path. Whether it is one rooftop unit on a retail box or a full plant serving a Class A office tower, you get one point of contact, code-compliant work, and equipment logged and verified before we leave the roof or mechanical room.

    What Our Commercial HVAC Repair Covers

    Root-cause diagnosis across refrigeration, hydronic, gas-fired, airside and control circuits
    Rooftop unit (RTU) and packaged-unit repair — compressors, economizers, gas-heat and blower faults
    Chiller and cooling-tower repair — compressors, refrigerant, condenser-water and controls
    Boiler and hydronic repair — burners, controls, pumps, zone valves and heat exchangers
    Air handler, fan-coil and VAV repair — motors, coils, dampers and actuators
    Refrigerant leak detection with EPA Section 608 compliant recovery and recharge
    BAS and rooftop controls troubleshooting, sensor calibration and sequence correction
    Documented findings with photos and a repair-vs-replace recommendation per unit

    Why Property Managers Call Com+ for HVAC Repair

    One vendor for every system in the building — RTUs, chillers, boilers, VRF, AHUs and controls
    24/7 emergency response so tenant comfort, occupancy and operations stay up
    Root-cause diagnostics with documented, photo-backed findings for your records
    Honest repair-vs-replace guidance backed by equipment age and run data
    Coverage for a single building or a multi-site portfolio under one point of contact
    Code-compliant work with COI and roof/mechanical-room access coordinated up front

    Our Simple Process

    From call to comfort in 4 easy steps

    1

    Dispatch & site assessment

    We confirm building access, COI requirements and equipment details, then get the right technician to the roof, plant or mechanical room — fast when it is an emergency.

    2

    Root-cause diagnosis

    We test the failed system under load across refrigeration, hydronic, electrical, airside and control circuits to find the true cause, not just the symptom that tripped the alarm.

    3

    Scope, quote & approval

    You get a documented scope with photos and a clear price before work proceeds. No surprise invoices and no scope creep without sign-off.

    4

    Repair & verify

    We complete the repair, verify performance across a full operating cycle, and leave each unit logged and labeled for your maintenance records.

    Types of Systems We Install

    Packaged & Rooftop Systems

    Gas/electric and heat-pump packaged rooftop units that carry the load for most retail, office and mixed-use buildings.

    • Compressor & economizer diagnostics
    • Gas-heat & heat-exchanger safety inspection
    • Curb, condensate & airflow correction

    Central Plant — Chillers, Boilers & Towers

    Air- and water-cooled chillers, hydronic and steam boilers, pumps and cooling towers serving larger buildings and campuses.

    • Compressor & refrigerant management
    • Burner, control & heat-exchanger service
    • Condenser-water & pump troubleshooting

    Airside, VRF & Controls

    Air handlers, fan-coils, VAV boxes, VRF systems and the BAS that sequences them across zones and floors.

    • Motor, coil & actuator repair
    • VRF reversing-valve & refrigerant diagnostics
    • BAS sequence & sensor correction

    The Com+ Mechanical Difference

    Commercial-only focus

    We work on packaged, central-plant and VRF equipment every day across NYC — not the occasional residential split system.

    All systems, one contractor

    Rooftop, chiller, boiler, VRF, airside and controls under one roof means no finger-pointing between trades when a fault crosses disciplines.

    Built for property managers

    Clear documentation, a single point of contact, and coordination with your building staff, tenants and COI requirements.

    Whole-portfolio coverage

    One vendor for one building or a hundred across multiple sites, boroughs and counties — with consistent reporting.

    Transparent Pricing

    No fees. No surprises. Just honest service.

    Most Popular

    Repair

    Custom Quote

    Approved repair scoped to the failed components and equipment.

    • Parts and labor scoped to the fault
    • Performance verified across a full operating cycle
    • Equipment logged and labeled
    • Workmanship backed
    Get Free Quote

    Maintenance Agreement

    Custom Quote

    Planned, whole-building maintenance to cut emergency failures across your portfolio.

    • Scheduled filter, belt, coil & combustion service
    • Priority emergency response
    • Portfolio-wide reporting
    • See our commercial maintenance plans
    Get Free Quote

    Pricing shown is a structure, not a quote. Final pricing is confirmed in writing after assessment.

    Own a Commercial Property?

    Business+ plans start at $499/year — includes 2 rtu tune-ups, 10% off all services, and priority scheduling.

    No ContractsSatisfaction Guarantee
    View Business+ Plans

    Equipment & Brands We Service

    Factory-trained technicians for all major HVAC manufacturers

    Trane logo
    TraneThe Apple of HVACFactory Authorized
    Carrier logo
    CarrierThe OG of Air ConditioningFactory Authorized
    Lennox logo
    LennoxPremium High-EfficiencyFactory Authorized
    American Standard logo
    American StandardTrane's Smarter TwinPreferred Partner
    Rheem logo
    RheemReliable & Drama-FreePreferred Partner
    Bryant logo
    BryantCarrier's Quieter SiblingCertified
    Goodman logo
    GoodmanHonest ValueCertified
    Ruud logo
    RuudRheem's Reliable TwinCertified
    Mitsubishi Electric logo
    Mitsubishi ElectricGold Standard for DuctlessFactory Authorized
    Daikin logo
    DaikinWorld's Largest HVAC ManufacturerFactory Authorized
    Bosch logo
    BoschGerman Engineering ExcellencePreferred Partner
    LG logo
    LGSurprisingly LegitPreferred Partner

    Don't see your brand? We service all major manufacturers! Call us to confirm.

    Proudly Serving Nassau County

    Fast, reliable service in your neighborhood

    Frequently Asked Questions

    Get answers to common questions about our services

    Do you offer 24/7 emergency commercial HVAC repair in NYC?

    Yes. Building failures don't wait for business hours, so we provide 24/7 emergency commercial response across the five boroughs, Long Island, Westchester, northern NJ and Stamford.

    What types of commercial HVAC systems do you repair?

    All of the major systems in a commercial building — packaged rooftop units, air- and water-cooled chillers, cooling towers, hydronic and steam boilers, VRF and split systems, air handlers, fan-coils and VAV boxes, makeup-air and exhaust units, commercial refrigeration, and the building automation system that controls them.

    Can one contractor really cover every system in our building?

    Yes — that's the point of calling Com+. When a fault crosses mechanical, electrical and controls, a single accountable vendor diagnoses end to end instead of three trades pointing at each other. It also means one point of contact and one consistent record of every repair.

    Can you service HVAC across multiple buildings in our portfolio?

    Yes. We support property-management companies and owners with multi-site portfolios, giving you one vendor, consistent documentation and coordinated scheduling across buildings, boroughs and counties.

    How do you handle COIs and building access?

    We coordinate roof and mechanical-room access, tenant notice and certificate-of-insurance requirements before mobilizing, so the technician isn't turned away at the door.

    Will repairs help with Local Law 97 and energy costs?

    A correctly running, well-maintained system uses less energy, which directly supports your building's emissions targets. For aging or repeatedly failing equipment, we'll show how efficient replacement options affect operating cost and your Local Law 97 exposure.

    Love Our Service? Share Your Experience!

    Manage a building we've serviced? A quick review helps other NYC property managers and building owners find us.

    5 stars • 500+ reviews

    Most Requested Services

    Our businesses' top picks for heating, cooling & air quality

    additional

    Repair vs Replace Commercial HVAC

    Learn More
    cooling

    RTU Installation

    Learn More
    cooling

    RTU Maintenance

    Learn More
    cooling

    VRF Installation

    Learn More
    cooling

    VRF Repair

    Learn More

    Building System Down? Call One Number.

    Tell us the building and the symptom — we'll get the right technician to the roof, plant or mechanical room and get your space conditioned again. Serving property managers, building owners and facility teams across the NYC metro, 24/7.

    Request Commercial Service